º» Á¦Ç°Àº ¹è·²ÀèÀ̳ª 2ÇÉ JST Ä¿³ØÅ͸¦ ÅëÇØ 6~12VÀÇ Àü¾ÐÀ» ÀÔ·Â¹Þ¾Æ 3.3V ¶Ç´Â 5V·Î Ãâ·ÂÇØÁÖ´Â Á¦Ç°ÀÔ´Ï´Ù. º¸µåÀÇ ¾çÂÊ ³¡¿¡ Çì´õ¸¦ ³³¶«ÇÏ¿© ±âº» ºê·¹µåº¸µå (400ÇÉ ¶Ç´Â 830ÇÉ, 830ÇÉ ¿©·¯°³·Î ÀÌ·ç¾îÁø ºê·¹µåº¸µå) ÀÇ +,-ÂÊ¿¡ ¿¬°áÇÏ¿© Àü¿øÀ» °ø±ÞÇØÁÙ ¼ö ÀÖ½À´Ï´Ù. ½ºÀ§Ä¡°¡ ÀÖ¾î ON/OFF¿Í 3.3v, 5v¸¦ ¼³Á¤ÇØÁÙ ¼ö ÀÖ½À´Ï´Ù. ÀÛµ¿ Àü·ù´Â 800mAÀÔ´Ï´Ù.
Description: This is a very simple board that takes a 6-12V input voltage and outputs a selectable 5V or 3.3V regulated voltage. All headers are 0.1" pitch for simple insertion into a breadboard. Input power can be supplied to either the DC barrel jack or the two pin header labeled + and -. Output power is supplied to the pins labeled GND and VCC. Board has both an On/Off switch and a voltage select switch (3.3V/5V). The two sets of four GND and VCC holes are spaced such that when connected to our Basic Breadboard both power busses will be powered. Note: Headers are not supplied. You will need to supply your own headers to connect this board to a breadboard. Check below for some breakaway header strips. Dimensions: 2.15x0.65" Features: - 6-12V input voltage via barrel jack or 2-pin header
- 3.3V or 5V regulated output voltage
- 800mA Operating Current
- ON/OFF switch
- Output voltage select switch
- Power status LED
- PTC fuse protected power
- 5.5x2.1mm center positive barrel jack
Documents:
|