These displays are small, but very readable due to the high contrast of an OLED display. This display is made of 128x64 individual white OLED pixels, each one is turned on or off by the controller chip. Because the display makes its own light, no backlight is required. This reduces the power required to run the OLED and is why the display has such high contrast; we really like this miniature display for its crispness!

The OLED itself require a 3.3V power supply and 3.3V logic levels for communication, but we include a 3.3V regulator and all pins are fully level shifted so you can use with 5V devices!

Features:

 OLED self-luminous, no backlight

 Screen size:0.96

 Resolution:128*64

 Color:Blue

 Communication method:IIC

 Ultra-Low power:

 Working temperature:-20-70

 Operating Voltage:3.3-5V

 Module size:<27mm*28mm

Applications:

 MP3

Head mounted display

Note: heavy impact or stress on the OLED will cause the breakdown of screen.

Programming

include

// with no jumpers the full address is 1 0 0 1 1 1 1 0 0 A2 A1 A0 0x27 is the default address for the board with no jumpers.

define PCA9555 0x27 // 0x27 is default address for the board with no jumpers.

                    // 0x20 is address for the  board with all jumpers.

// COMMAND BYTE TO REGISTER RELATIONSHIP FROM PCA9555 DATA SHEET // At reset, the device's ports are inputs with a high value resistor pull-ups to VDD // If relays turning on during power up are a problem. Add a pull down resistor to each relay transistor base.

define IN_P0 0x00 // Read Input port0

define IN_P1 0x01 // Read Input port1

define OUT_P0 0x02 // Write Output port0

define OUT_P1 0x03 // Write Output port1

define INV_P0 0x04 // Input Port Polarity Inversion port0 if B11111111 is written input polarity is inverted

define INV_P1 0x05 // Input Port Polarity Inversion port1 if B11111111 is written input polarity is inverted

define CONFIG_P0 0x06 // Configuration port0 configures the direction of the I/O pins 0 is output 1 is input

define CONFIG_P1 0x07 // Con